Describe General Touch Interaction Guidelines here.

General Touch Interaction Guidelines

The minimum area for touch activation, to address the general population, is a square 3/8” on each side (10 mm). When possible, use larger target areas. Important targets should be larger than others.

There is no distinct preference for vertical or horizontal finger touch areas. All touch can be assumed to be a circle, though the actual input item may be shaped as needed to fit the space, or express a preconceived notion (e.g. button). Due to reduced precision and poor control of pressure, but smaller fingers, children who can use devices un-assisted have the same touch target size.

Minimum area for touch activation. Do not rely on pixel sizes. Pixel sizes vary based on device and are not a consistent unit of measure

Targets

The visual target is not always the same as the touch area. However the touch area may never be smaller than the visual target. When practical (i.e. there is no adjacent interctive item) the touch area should be notably larger than the visual target, filling the "gutter" or white-space between objects. Some dead space should often be provided so edge contact does not result in improper input.

In the example, the orange dotted line is the touch area. It is notably larger than the visual target, so a missed touch (as shown) still functions as expected.

Visual target compared to the touch area. The touch area should never be smaller than the visual target

Touch area and the centroid of contact

The point activated by a touch (on capacitive touch devices) is the centroid of the touched area; that area where the user’s finger is flat against the screen.

The centroid is the center of area whose coordinates are the average (arithmetic mean) of the co-ordinates of all the points of the shape. This may be sensed directly (the highest change in local capacitance for projected-capacitive screens) or calculated (center of the obscured area for beam-sensors).

A larger area will typically be perceived to be touched by the user, due to parallax (advanced users may become aware of the centroid phenomenon, and expect this).

The centroid area compared to the area touched. Due to screen parallax, we typically perceive a larger area exists to touch

Bezels, edges and size cheats

Buttons at the edges of screens with flat bezels may take advantage of this to use smaller target sizes. The user may place their finger so that part of the touch is on the bezel (off the sensing area of the screen). This will effectively reduce the size of their finger, and allow smaller input areas.

This effective size reduction can only be about 60% of normal (so no smaller than 0.225 in or 6 mm) and only in the dimension with the edge condition. This is practically most useful to give high priority items a large target size without increasing the apparent or on-screen size of the target or touch area.

By using the space provided on the screen bezel, the actual target size can be slightly reduced


Next: Fitts' Law


Discuss & Add

Please do not change content above this line, as it's a perfect match with the printed book. Everything else you want to add goes down here.

Examples

If you want to add examples (and we occasionally do also) add them here.

Make a new section

Just like this. If, for example, you want to argue about the differences between, say, Tidwell's Vertical Stack, and our general concept of the List, then add a section to discuss. If we're successful, we'll get to make a new edition and will take all these discussions into account.